Camera head lamp with integrated wireless signal receiver, and weighing only 350 grams.<\/p>\n\n\n\n
This\ncompletely novel head light design contains a bi-color light with color\ntemperatures of 3,200 and 5,400 Kelvin. At 5,400 K it achieves a brightness of\n1000 Lux \/ 1m, while at 3,200 K the brightness is 700 Lux \/ 1m.<\/p>\n\n\n\n
The light\ndensity is kept relatively low through the use of a 70mm x 140mm light panel.\nThe wide lighting angle and the optionally insertable diffusion gel permit achieving\na very even lighting.<\/p>\n\n\n\n
If a manual\nadjustment of the brightness should be necessary, the light can be switched to\na manual mode and the brightness can be adjusted via two integrated\ncontrollers.<\/p>\n\n\n\n
The\nnonlinear control curve of the LED is linearized inside the lamp and mimics the\ncharacteristics of a conventional incandescent light. Internally, the lamp is\nworking with ca. 4000 brightness levels \u2013 as a result, it permits changes in\nthe brightness while in \u201eON\u201c mode, without any noticable jumps in brightness\nduring the adjustment.<\/p>\n\n\n\n
A\nDMX-Controller decodes the control signal that is sent to the lamp via the\ntransmitter. A controller can be connected with up to 4 different lamps, which\ncan then be controlled independently of each other through a total of 8 DMX\nchannels. <\/p>\n\n\n\n
Every lamp\nuses the data from two DMX channels to adjust each of the two color\ntemperatures independently from 0-100%. This way, the light designer has\ncomplete control over both brightness and color temperature.<\/p>\n\n\n\n
The DMX\nstarting adress is set at the controller.<\/p>\n\n\n\n
The wireless\nsignal transmission uses frequencies in the 2,4 GHz range, which are also used\nby WLAN technology \u2013 however, it is not in fact using WLAN technology.<\/p>\n\n\n\n
Through the\nability to switch frequencies and the creation of groups within a frequency,\nseveral systems can be operated in parallel.<\/p>\n\n\n\n
Power is\nsupplied through an attachable power cable with a voltage of 12-24 volts. The\nrequired current at maximal usage of both color temperatures is about 1200 mA.\n\n\n\nTo make it easier to set up the device, the received\nDMX data, signal reception strength and the supply voltage of the lamp are\nshown on the controller. Moreover, the status of the lamp (manual \/ remote) is\nshown in the controller display. Through\nthe use of a test button, the lamp can be reached via wireless signal even\nwithout the presence of a DMX signal. A valid DMX signal is also indicated in\nthe controller display.\n\n\n\n<\/p>\n","protected":false},"excerpt":{"rendered":"
Camera head lamp with integrated wireless signal receiver, and weighing only 350 grams. This completely novel head light design contains a bi-color light with color temperatures of 3,200 and 5,400 Kelvin. At 5,400 K it achieves a brightness of 1000 Lux \/ 1m, while at 3,200 K the brightness is 700 Lux \/ 1m. The … Continue reading Technical Description<\/span>